Select Page

IEC 61347-2-11 Testing

Lamp controlgear – Part 2-11: miscellaneous electronic circuits used with luminaires

IEC 61347-2-11 Scope:

IEC 61347 2 11 and EN 61347 2 11 testing specifies general and safety requirements for miscellaneous electronic circuits used with luminaires for use on A.C. supplies up to 1000 V at 50 Hz or 60 Hz and/or D.C. supplies up to 250 V. This part does not apply to circuits or devices for which specific IEC standards are published.

NOTE: Examples of miscellaneous electronic circuits used with luminaires are

  • Electronic ballast control circuits;
  • Switching circuits used in association with daylight and/or presence sensors;
  • Circuits to assist EMC performance;
  • Intermittence and similar devices used with lighting chains;
  • Earth leakage or open-circuit protective devices used with neon transformers.

Keystone Compliance assists manufacturers with IEC 61347-2-11 and EN 61347-2-11 test compliance. Please contact us for more information on how Keystone Compliance can assist you with identifying and fulfilling your IEC 61347-2-11 test lab needs.

Related Standards:

IEC 61347-1 General requirements

IEC 61347-2-1 Starting devices (other than glow starters)

IEC 61347-2-2 D.C. or A.C. supplied electronic step-down convertors for filament lamps

IEC 61347-2-3 A.C. and/or D.C. supplied electronic control gear for fluorescent lamps

IEC 61347-2-7 Battery supplied electronic controlgear for emergency lighting (self-contained)

IEC 61347-2-8 Ballasts for fluorescent lamps

IEC 61347-2-9 Electromagnetic controlgear for discharge lamps (excluding fluorescent lamps)

IEC 61347-2-10 Electronic invertors and convertors for high-frequency operation of cold start tubular discharge lamps (neon tubes)

IEC 61347-2-12 D.C. or A.C. supplied electronic ballasts for discharge lamps (excluding fluorescent lamps)

IEC 61347-2-13 D.C. or A.C. supplied electronic controlgear for LED modules